Recent content by DaveB in VA

You should also check out Teach Me Bass Guitar by Roy Vogt at [Invalid or Expired Link Removed]. This is a comprehensive 20 lesson course that goes from beginner to advanced. This is the course I used when I started learning to play bass when I was 60. I highly recommend it.

I have an SR-505 that I bought new in 2013. The toggle switch selects the center frequency for the mid boost/cut control. the up position is 250Hz and the down position is 600Hz.

And not just us, but all across the Talk Bass community.

Looks like this is not the problem. I'm reading about 13 ohms between pins 4 and 5 on all three tubes. There is continuity between pin 5 of V1 and pin 4 of V2 and between pin 5 of V2 and pin 4 of V3. I detected no voltage on either pin 4 or pin 5 on any of the sockets using the blue wire on...

Thanks, I'll open it up tomorrow and let you know the results.

I don't have a spare. I'll order one from you guys next week. That would be so much easier than shipping the amp all the way across the country. Can I check the tubes with an ohm meter?

I am the original owner and can probably provide proof that I bought it from Sweetwater. I don't remember if I sent in the registration. I agree that it is time to engage the pros. I'll contact the service department next week. Looks like I'll have to scare up a box for shipment.

@agedhorse I have a problem with my TT800. When I turned it on a couple of weeks ago, I got no output on either channel. The Tuner Output is working ok. Also, I determined that the power amp is working by using my Subway+ Preamp into the effects return of the TT800. After looking at the Block...

You might get more responses over on the "Guitar players corner!" thread.

Have you checked to make sure that the fan is working?

I was planning to use velcro to attach the DI to the board. I just wanted to remove the feet so that the velcro mated properly.

A question for @agedhorse. I want to mount my Subway+ DI to a pedal board. Can I simply remove the screws holding the feet, or will that leave nuts loose in the innards?

Do the holes in the template line up with the screw holes in the OneSpot?

I've always been impressed by your stage dress, as well as with your playing. I miss seeing you guys at Wegmans.

Teach Me Bass Guitar by Roy Vogt worked for me. I highly recommend it. [Invalid or Expired Link Removed]