Recent content by johnfitz44

Pm Sent.

I'm interested. Sent you a pm.

Thanks. That's what I thought. The GK will handle a 4ohm load. Just curious, which speaker in that scenario will be louder? The one with the least resistance (i.e. the 8 ohm 15)?

I have a blown voice coil in a 15" speaker in a hybrid cabinet (Ampeg cabinet, one 10, and one 15). I replaced both speakers getting this cab up and running about a year ago. Both speakers are replacement speakers and are/were 16 ohms run parallel? series? can't remember. Total load with a...

I contacted him about a week ago. He doesn't want to ship. He did say he would drive 50-100 miles.

GK 700RB-II head. I was planning on running out of the effects loop into a Rane DC-24 for the split band compression capabilities and then to a BBE 482i (I know everyone's not a fan, but I like'em for bass). I know BBE suggests putting their maximizers as far down the signal chain as...

PM sent :bassist:

Paypal payment sent. I've been looking for one of these. Thanks Jonathan.:bassist:

PM sent :)

I knew it would be a quick dumb question. To be honest I wasn't even seeing the red. Just the solder. Perhaps it's time for a color blind test. FWIW I tried the 9 volt test and couldn't seem to get a connection either way to bump the speaker. For the future, do you put the positive side of...

[Invalid or Expired Link Removed] Bought this 10" speaker off of musicman7722 (thanks!). It's an avatar neo 10" (modded eminence I believe). Anyway, I can't figure out which side of this speaker is positive and which is negative? There is what might be a slight "- -" marking and solder on...

Yes, it appears I have the room for say 7.44" deep to get down to about 48hz (given my measurements are correct). Can I just build a box 7.44" deep surrounding the vent and see what happens?

So, say I want to shooot for 48Hz. I build an elbow 6.16" deep like this: [Invalid or Expired Link Removed] Following say these rules for slot/ducts: Link Removed

Box size for the 15" speaker 3.25 cubic feet. Taking into consideration the displacement with the driver in the box = ??? 2.9 cubic feet ???

Do you mean something like this: [Invalid or Expired Link Removed] If correct, only concern I have is the top of the duct is headed straight for the sealed 10" driver box. Concern? If not, that's what I'm gonna do! Wheh!