Recent content by metalface

Is this possible without interference and other noises? my guitarist is doing a similar setup but he gets all kinds of weird sound and terrible feedback. The "Issue" I'm having is I want the tone from my Ampeg svt 3 pro but i want the volume of my Hartke LH1000 because im using a avatar b410...

But computers keep cool by having negative pressure inside the case, having all the fans blowing out and the intake being the filter on the front makes it cooler than the air outside, and keeps the unit clean since the intake is the filter, instead of the rear of the case. just my theory

If you look closely, the fan is blowing IN, look at the other fans, they are blowing OUT, i reversed mine so you can see the label from the outside of the case, it blows OUT now

it was wired that way from the factory im guessing...what i did was switched the main rear fan around so it blows out the rear, as do the ones on the power amp blocks on the left and right sides, so now the air flow is being drawn into the filter on the front and out the back by all 3 fans, like...

I have my settings on 5-5-5, which in the manual is mid's scooped, whatever hartke thinks sounds good i think they say, so its not flat, but its "factory" eq settings you could say, i have it up so high because im using it bridged at 4ohms into an Avatar B410 2000w cab, its an early one with the...

I was wondering if anyone out there with one of these amps has noticed that the rear large center fan is blowing in. There is a filter on the front but if the fan is blowing IN the back then nothing is going into the filter from the front. Is your amp setup the same way?, the two side fans on...