Recent content by The Derwood

Thank you everyone! It was the contacts in the battery box. It's back to sounding like a bass with some balls again! Have a great week! Sincerely, Darren

Hey everyone! Hoping for some input from the brain trust. My 2002 StingRay 3EQ is noticeably quieter than the other basses. It’s an active bass and I’ve replaced the batteries. It’s hardly audible in my active bass amp input and only somewhat normal in the passive input. Understandably, the...

hello everyone, I’m looking for suggestions on an amp head. I built the cabinet with with 4 Eminence CA1059s. They’re rated 8ohm and 500w. I originally had selected and Eden WT800 but it was broken so I’m starting from scratch. I’m curious if it’d be a disservice not using an Eden head with...

Thank you so much - So the idea is if I run this as an 8 ohm cabinet. I'm sure it'll be fine volume-wise and if I want to run another cabinet there's less of a likelihood of something going wrong?

So please forgive my ignorance - it appears this amp can run at 2 ohms. What would be the benefit of running the cabinet at 2 ohms over 8?

Good Morning Everyone, I have an Eden WT 800C and I'm made my own cabinet with four Eminence CA1059s (the 8 ohm version). What is the most best method to wire the speakers? I've included a picture of the back of my amp to give a little more context. Thank you again. Sincerely, Darren

Hey Everyone! Thanks so much for the help. I wasn't getting notifications people were responding so I was under the impression it went unanswered. I confirmed the speakers were in fact, 8 ohms and 500 watts each. So I think I'll scrap the 15" for now. This community is great and I'm very...

Good Afternoon, I have two eminence CA1059s which are 10" drivers with 500 watts and 8 ohms I'm looking to make another cabinet with a 15" driver also 500 watts and 8 ohms Q1. Should I run the two tens in parallel or in series Q2. What power requirements should I look for with the amp head...