repair tips

  1. T

    Double Bass Help with Neck

    I need to attach a new neck I have to my bass. The neck joint is too long and needs to be cut down so that fretboard wont be sticking out too far. I am probably not using proper terminology so please see picture. How far should the neck joint extend past the body? The pencil mark is flush.
  2. Nisse Palm

    Double Bass For European customers: order The Handy Double Bassist here

    The Handy Double Bassist
  3. The Huff

    Repair help on headless bass

    Can anyone show me what I need to replace this metal nut (see photos)? I have stripped the female threads of the E-String because it took a lot of pressure to get it done in the first place. I don’t see any other way than to replace it. I love this bass and have had it over 30 years. I want...
  4. swagbotbilly

    Truss rod nut too big for headstock hole?

    Hi all, I got ahold of some cheap beat up basses I wanted to fix up for fun and give away as starter basses. Started with cleaning and truss adjustments, figured if I can't do that they're next to worthless After getting some rust off with WD-40 I noticed that while the nut isn't stripped at...
    • swagbotbilly
    • Thread
    • headstock headstock front headstock repair neck repair repair tips repairs repairs/renovations truss rod adjustment truss rod nut
    • Replies: 40
    • Forum: Hardware, Setup & Repair [BG]
  5. Y

    Peavey max 115

    Hi, I am looking for a repair manual for Peavey Max 115 300 watts bass amp. I think I have my fuse blown but I was not able to locate the fuse. Can someone please help me with the repair manual? YS
  6. Daniel Kutcher

    Eden D410T repairs...halp!

    OK I want to do some maintenance and repair on my Eden D410T. How do I access the interior? There’s only a small port in the back of the cabinet and it’s hard to see what I’m doing in there if I stick my hand in the hole. (That’s what she said) Am I supposed to remove the back panel of the cab?
  7. whitelines

    HELP needed from tube amp gurus! b15n distortion and fade problem

    Hey tube amp experts (@agedhorse and friends...), I could use some advice. My early 60's Ampeg b15n usually sounds great, but occasionally starts to hum and the output gets softer and distorted. It usually does not do this, but this time, I caught it on video. When it gets in this mode...
  8. The Mackie

    Tech 21 foot switch receiving no signal feed

    I just joined this forum and was hoping someone on here might be able to give me some information about a problem that just occurred in regards to my foot switch suddenly having absolutely no signal. I have a Landmark 300, which I run through a Furman AR-117 power conditioner, and have the AR3-B...
    • The Mackie
    • Thread
    • circuit board malfunction di troubleshooting landmark 300 malfunctioning foot switch repair tips signal loss tech 21
    • Replies: 0
    • Forum: Miscellaneous [BG]
  9. The Mackie

    Tech 21 AR3-B foot switch no longer working

    I just joined this forum and was hoping someone on here might be able to give me some information about a problem that just occurred in regards to my foot switch suddenly having absolutely no signal. I have a Landmark 300, which I run through a Furman AR-117 power conditioner, and have the AR3-B...
Top Bottom
Back