Dismiss Notice

Psst... Ready to join TalkBass and start posting, make new friends, sell your gear, and more?  Register your free account in 30 seconds.

210 bracing

Discussion in 'Amps and Cabs [BG]' started by JonnyAngle, Dec 30, 2012.


  1. JonnyAngle

    JonnyAngle Dropping Acid Pedal Etching .com Supporting Member Commercial User

    Nov 24, 2008
    Maple Grove, MN
    DroppingAcidPedalEtching.com, JPTR FX North American Distributor
    Here's the 210 I'm building. I don't have the Ports in yet, but do I need to brace it? It's.75" 7 layer plywood. Each chamber is 1 cubic foot.
     
  2. astack

    astack Supporting Member

    Nov 12, 2011
    Washington, DC
    I'd say no given it's 3/4" ply, 10's won't be pumping out crazy SPLs, and you already have the divider as bracing.

    What speakers are you planning on using, out of curiosity?
     
  3. JonnyAngle

    JonnyAngle Dropping Acid Pedal Etching .com Supporting Member Commercial User

    Nov 24, 2008
    Maple Grove, MN
    DroppingAcidPedalEtching.com, JPTR FX North American Distributor
    I'm using eminence s2010's. I didn't think I'd need bracing either, just double checking
     
  4. JonnyAngle

    JonnyAngle Dropping Acid Pedal Etching .com Supporting Member Commercial User

    Nov 24, 2008
    Maple Grove, MN
    DroppingAcidPedalEtching.com, JPTR FX North American Distributor
    And it's done sans the grille. Notice the side Ports. It's within an inch or two of the ampeg micro vr 210