Brassmaster "clone" demo

[rcubed]

Cheers for the headsup there mate
But I do plan on using a SaNSamp / Tube pedal (depends on the board I use it with) as my output to Amp.

I was planning to use a BB style enclosure, like you I noticed, but with an accessory volume output I'm wondering about finding a bigger enclosure now.........
Would I be right in assuming a 500K pot would do the job?

500K would work, but it's probably overkill.

 

[Ali B]

I forget.

I was kicking myself for not writing them down. Looking at the GeoFex shematic, I think I changed the values of C1, C2, C7 and C8. I need to open up the pedal and figure out the exact values. I also added 1M ohm pull down resistors to the input and output of the circuit to quiet down the popping of the switch. I soldered them to the traces. I wish my camera was working or I would have pictures.

I realise this was a long time ago now, but did you ever figure out the cap values? The clean blend on my clone is subtly lighter in the low end and I'd like to put the heft back!

 

[Alien8]

I'm interested too... the GGG kit is great, but that bit of low end missing would be nice to have back...

Time to experiment... maybe Germanium sounds good too!? Or even a tone control on the cleans to roll off some highs.