Can you help me with some wiring?

[Kabal]

I plugged in a bass I've been putting together and no sound is coming out. I checked all the volumes, cables and battery related possibilities so now I'm down to the pre/pup possibilities.

There is a very very faint hiss coming from the speakers when I flip one of the switches but no sound from the strings being played. Does this mean the signal is still reaching the amp?

Here's the preamp--Link

And the pups--[Invalid or Expired Link Removed]

I'm using a p/j combination, one is in series and the other in parallel. I have the two red wires soldered to the EQ board like the preamp diagram indicates along with one white wire because one of the pickups is in parallel. Could this be what's causing the problem?

I followed the pup instructions exactly as far as what wires should be paired or sent to ground but right now I'm at a loss. Any ideas?

 

[Kabal]

I went ahead and switched both pickups to series in case the white wire was throwing everything off. When I plugged in the bass there was no noise at all I seemed to go backwards!

Then I checked out a similar diagram Invalid Link Removed and wired it that way but still nothing

Can anyone give me any insight?

 

[fleabee]

Can you take a detailed picture of your wiring?

 

[Kabal]

The camera I was using was very disagreeable but these were the best I could do Pics

I don't know if they're clear enough to help but hopefully they can reveal something

 

[fleabee]

My eyes aren't the best, but from experience make sure that the output jack solder is perfect and that no wires are touching a part of the output jack that wasn't intended. This could very easily cut out all volume.

 

[Kabal]

I fixed the solder and it works!!

Thank you fleabee you have no idea how disheartened I was getting.

 

[fleabee]

woohoo!!