Hello all!
I’ve been jonesing for a new bass recently and finally took the plunge last night on a MIJ Orville EB-3. I always planned an EB-3 style bass to be the next one I’d get, but I just couldn’t swallow the cost of a true vintage Gibson. However, with everything going on right now, when it arrives, I’d like to wipe it down and make sure is all nice and clean before laying down some heavy and thick Jack Bruce bass lines.
How should I do this? I’ve looked around and it appears that, at least on the Les Paul Orvilles, they appear to have a nitro finish. However. I don’t know if the same finishing was used on the EBs. On my other two basses (Guild SF-II and a Squier 70s Jazz) poly was used. I did a little bit of digging and found that rubbing alcohol on poly is ok, but can be damaging for nitro.
If anyone has any ideas on how to clean the new bass or info on what finished was used, it’d be greatly appreciated!
I’ve been jonesing for a new bass recently and finally took the plunge last night on a MIJ Orville EB-3. I always planned an EB-3 style bass to be the next one I’d get, but I just couldn’t swallow the cost of a true vintage Gibson. However, with everything going on right now, when it arrives, I’d like to wipe it down and make sure is all nice and clean before laying down some heavy and thick Jack Bruce bass lines.
How should I do this? I’ve looked around and it appears that, at least on the Les Paul Orvilles, they appear to have a nitro finish. However. I don’t know if the same finishing was used on the EBs. On my other two basses (Guild SF-II and a Squier 70s Jazz) poly was used. I did a little bit of digging and found that rubbing alcohol on poly is ok, but can be damaging for nitro.
If anyone has any ideas on how to clean the new bass or info on what finished was used, it’d be greatly appreciated!
