How do I remove the screen on my svt 810 Sorry if it's a dumb question but I can't figure it out lol Any help please
Enjoy the benefits of a premium membership!
Upgrade Account
-
TalkBass has been independent since 1998. Add your voice.
Create a free account to reply to discussions, view embedded media, and browse with fewer display ads.
Join free Log in
Want zero display ads or expanded classifieds tools? Compare plans.
I remove the screen on my svt 810
- Thread starter seangonzo626
- Start date
I saw a YouTube video where the person recommended backing out one of the screws on the name plate a little and pulling on that. It may have been an official Ampeg video.
Yep, it was....a YouTube search turned this up:
I've found that if you carefully insert a flat blade screwdriver between the cabinet and the grille frame and gently pry sideways, it'll pop off too. You have to be careful not to dent the cabinet.
I usually did the flathead in the corner trick when I had my 610, but you do have to be careful not to damage the cab. I've never actually tried the pull a screw method, but that's probably the best way.
i'm lucky...my grill frame has shrunk so much over the years that all i have to do is pull the picks out that keep it from rattling and it pretty much falls out 
when youput it back in you could place a ribbon under with the end sticking out to make the process easier next time
A narrow puddy knife instead of a flat screw driver will spread out the prying pressure and reduce chance of digging into the edge of the cab.
