• TalkBass has been independent since 1998. Add your voice.
    Create a free account to reply to discussions, view embedded media, and browse with fewer display ads.
    Join freeLog in
    Want zero display ads or expanded classifieds tools? Compare plans.

Mods pls delete

If you find a split coil Jazz pickup that has close to the same resistance as the P pickup then it will be quiet, and there will be very little volume drop when using the Jazz pickup. The best combination I have found so far, is a Duncan SPB-1 paired with a Fender Super 55 (if you can find one). You want them in parallel

You probably did overreact a bit, but its understandable after being laid up for 3 days.
 
  • Like
Reactions: Sam N
Aw, dont be so reactive.
Don't tell me not to be so reactive!!!

homer%20Drunk_and_armed_on_the_rollercoaster_zpszp5zdwvb.jpg
 
  • Like
Reactions: Nev375
I've got a passive PJ wired in parallel with a VVT control configuration. There is a very slight volume drop with both pups on, but it is not enough imo to make wiring in a resistor worth the trouble.

I was JUST about to write this out myself!! I don't know if it was the pickup height or type of pickups, but I had a set of Bartolini P+J's in a Japanese Ibanez SR800. Whenever I did the P+J full on, there was a volume drop as compared to the P alone. I found that it was minimally noticed when I backed SLIGHTLY off the J volume and left the P full on. Something to keep in mind OP, might want something that you could do a "set it and forget it" config for the J pickup volume. Get it adjusted where you want and then have the push/pull knob to kick it on or off.

FWIW, I really don't think this is a bad idea at all. I'd personally use mine like a scoop switch for popping and slapping. The adding in the J does scoop the midrange out some, so that would be great. Maaannn...now I'm gonna try and wire one of these up at home for myself! :p