I have a DC Brick I have been using without issues. Noticed after buying a second (new) one that the wall wart for the old one is not original, and is rated at 1A. The new DC brick came with the original MXR wart, rated at 2A.
Total power draw from the current setup on the old DC Brick is somewhere around 300-500 mA, and works fine.
Would the 1A wall wart cause any issues in the long term or otherwise, as long as the power draw on the DC Brick stays below 1A?
Total power draw from the current setup on the old DC Brick is somewhere around 300-500 mA, and works fine.
Would the 1A wall wart cause any issues in the long term or otherwise, as long as the power draw on the DC Brick stays below 1A?
