• TalkBass has been independent since 1998. Add your voice.
    Create a free account to reply to discussions, view embedded media, and browse with fewer display ads.
    Join freeLog in
    Want zero display ads or expanded classifieds tools? Compare plans.

Peavey AlphaBASS, Standing End-Up in a Rack Case?

Count Bassie

Supporting Member
Jun 10, 2006
16,784
64,486
Smithfield, RI
I ask because it's a tube amp, and wonder if it's an issue. I'm going to use it with a 215 cab that's not very deep, and the case will stick off the backside of the cab. Also it will be just a bit top-heavy, so I thought I might stand it up on the floor next to the cab.
Thoughts, knowledge, advice?...
Thanks for your time.
 
Questions that pop into my mind:

1) Are the transformers appropriately anchored for vertical operation?
2) Are the preamp tube sockets tight enough to keep the tubes in place without retainers?
3) Will a hot zone develop around the uppermost power tubes and affect reliability?

Personally I wouldn't do it, but then again I tend to err on the conservative side when it comes to such things.
 
Questions that pop into my mind:

1) Are the transformers appropriately anchored for vertical operation?
2) Are the preamp tube sockets tight enough to keep the tubes in place without retainers?
3) Will a hot zone develop around the uppermost power tubes and affect reliability?

Personally I wouldn't do it, but then again I tend to err on the conservative side when it comes to such things.
These are the kind of questions... The hot zone question is very practical, and the one I can't really address- it is what it is. That's the one that stops me dead. I'm ready to let this go, lol.
Thanks for the thoughtful response.
 
Gut shot "found" by DuckDuckGo:

iu