Pickup Installation for P bass. Please help!

[JaneBass1]

I am replacing pickups and installing basslines.

I followed the instructions and soldered the cables.

I am screwing down the pickups to the body, but the top pickup always seems loosen.

If I flip the body up and down I can hear the pickup hitting the pickup case very lightly.

Also getting the cables to get out of the way of the pickup is a pain in the butt.

How low are the pickups supposed to be. I remember how my old pickups when being pushed down felt like if they had a spring on the bottom. These new ones not so much.

Please help me out with these 3 issues:
- Pickup being loosen inside the pickup case
- Cables around the pickup
- Depth of the pickup

 

[Bofee]

Typically there's a piece of foam rubber that comes with the PUPs. Stick a piece of this under the pickup(s) to hold the winding in the cover.

 

[lowtide]

I typically eliminate the springs in most Ps and Js by using about a half inch thick by three quarter inch wide piece of semi-dense rubber under each pup.

 

[GeneralElectric]

I typically eliminate the springs in most Ps and Js by using about a half inch thick by three quarter inch wide piece of semi-dense rubber under each pup.

+1

 

[4Mal]

mouse pad is a nice material for this ... I run my p-bass pickups fairly low into the body. I don't want any clack from strings hitting the poles and in general I feel I get better tones with the pickups a little lower. Not quite as much signal but then I would prefer that what signal there is - carries better tone or at least the tone that I prefer.