PJ Wiring - VVT 3 Way PUP selector - how to?

[Steviewevie95]

So my question is how would I go about wiring my bass as a VVT 3 way switch?
I’m using 250k pots for the Volumes and Tone. My main concern is that I’ll lose volume or tone from my P pickup if I decide to toggle to just that pickup. I’m trying to achieve a more “true” P bass tone without giving up the Jazz bridge.
I have seen the Flying V and Explorer wiring diagrams but I just wanted to double check.
By the way I am putting a Seymour Duncan Antiquity II P and J bridge into an Fender American Elite Precision Bass and making it conpletely passive.

 

[James Collins]

Any way you wire it will be some compromise in lost tone for better volume or lost volume for brighter/clearer tone with passive wiring and two volume controls.

 

[bigtone23]

I'm not able to supply a wiring diagram, but I think the pickups would have to go to their respective volume pots before the switch. Seems a little compromising, though.
WalterW has a thread on here about doing an ungrounded/no load M/N blend pot. This will get you the ability to blend and get fully independent pickups when set to the extremes. Ultimate No-load Ungrounded Blend Pot (Pics!)

 

[Steviewevie95]

Thanks guys! I was able to get it all wired up after some trouble shooting. It does have volume loss / 60 cycle hum / buzzing when in Pj or J position but otherwise sounds awesome (especially when solo’d the neck PU)
Bigtone23 - I’ll make sure to check it out! Thanks for the link!