1. Please take 30 seconds to register your free account to post, make friends, earn reward points at our store, remove most ads and more!  
     
    TalkBass.com has been uniting the low end since 1998.  Join us! :)

quick QSC RMX 1450 question.

Discussion in 'Amps and Cabs [BG]' started by xJasonSmithx, Mar 30, 2004.


  1. xJasonSmithx

    xJasonSmithx Supporting Member

    Jun 25, 2003
    Denver, CO
    If its Not bridged will it send 700 watts into my 4 ohm cab? I am alittle confused about how the specs are written on the site.

    -Jason
     
  2. Bob Lee (QSC)

    Bob Lee (QSC) In case you missed it, I work for QSC Audio! Gold Supporting Member Commercial User

    Jul 3, 2001
    Costa Mesa, Calif.
    Technical Communications Developer, QSC Audio
    Into 4-ohm loads, the amp will put out up to 450 watts on each channel.
     
  3. xJasonSmithx

    xJasonSmithx Supporting Member

    Jun 25, 2003
    Denver, CO
    Ive never had any experiance w/ pre/power setups but i always figured if it was 1400 bridged @ 4 ohms then it would be 700 @ 4 when no bridged, Are most poweramps this same way?

    -Jason
     
  4. Bob Lee (QSC)

    Bob Lee (QSC) In case you missed it, I work for QSC Audio! Gold Supporting Member Commercial User

    Jul 3, 2001
    Costa Mesa, Calif.
    Technical Communications Developer, QSC Audio
    If it were 1400 watts bridged into 8 ohms, then it would be 700 watts per channel into 4 ohms.

    The RMX 1450 puts out up to 450 watts per channel into 4 ohms, so it would be able to do 900 watts into 8 ohms in bridged mono.