• TalkBass has been independent since 1998. Add your voice.
    Create a free account to reply to discussions, view embedded media, and browse with fewer display ads.
    Join freeLog in
    Want zero display ads or expanded classifieds tools? Compare plans.

Sadowsky SBP4K Preamp Wiring Questsion...

MMMiguelito

"...I'm afraid I can't do that, Dave".
Jul 18, 2008
67
52
Massachusetts
www.facebook.com
Hello learned colleages...

I just bought a SBP4K and I'm trying to wire it up. I assume, like with the Audere it's replacing (bass took a spill, wiped out the volume pot, and now they're OOB 😞) all the ground wires get tied together. I did that, and plugged it in. Just buzz.

Opened up the control plate while it was plugged in to see if a wire came loose, and inadvertently touched the pickup with the plate... Voila! Hum gone, bass sounds great. So this tells me that there's a grounding problem.

Problem is, I don't know where to attach a ground wire to the plate. The schematic provided with the preamp is ambiguous... and it's written in German. Scoured the interwebs, found diagrams for just about everything except the SBP4K.

If there's anyone out there who's familiar with this piece... I'd really appreciate some guidance. Thanks in advance.

Your pal,
Mikey
 
Hi Mikey,

I just installed a Sadowsky Preamp in my 2017 Active Jazz Bass. Luckily, I had seen a video by Low End Lobster comparing preamps & Lobster mentioned that it would be necessary to ground the cover plate by using some copper shielding tape. I tried just using the shielding tape, but it wasn't easy to work with so I just ran a wire from the grounding screw & used the copper tape to position it so the wire end was under the edge of the cover plate. That did the trick I guess because I'm having no noise issues. Hope this helps.

Best,
Bruce
 
Upvote 0
Hi Mikey,

I just installed a Sadowsky Preamp in my 2017 Active Jazz Bass. Luckily, I had seen a video by Low End Lobster comparing preamps & Lobster mentioned that it would be necessary to ground the cover plate by using some copper shielding tape. I tried just using the shielding tape, but it wasn't easy to work with so I just ran a wire from the grounding screw & used the copper tape to position it so the wire end was under the edge of the cover plate. That did the trick I guess because I'm having no noise issues. Hope this helps.

Best,
Bruce
Ha! That's funny - I did the exact same thing.
 
Upvote 0

Latest posts