SOLD Standard Squier P Neck, 1.5" wide.

Discussion in 'For Sale: Parts, Strings, and Accessories' started by bluesfanjp, Nov 3, 2018.

  1. bluesfanjp

    bluesfanjp Supporting Member

    Nov 17, 2015
    This is a 2010, if I interpret the SN right, standard Squier P neck. It is however 1 1/2 inches wide at the neck. Made in Indonesia. I never noticed this before but the SN ends in 666 in case you are sensitive to such things. I'm indifferent I guess. Overall its in nice shape with barely noticeable fret wear. Truss works as it should and there's no pop on the skunk stripe. There are some small finish chips at the tip of the headstock (see pic). There are also some small lines in the finish on the back of the neck that you will feel under your thumb. Not deep but like it got leaned against a hard surface (see pic).
    You will also notice a mark on the back of the neck up towards the headstock. Its totally under the finish with no defects in that area. As far as I can tell it occurred naturally in the wood.
    $60.00 delivered in the CONUS

    Attached Files:

  2. tjh


    Mar 22, 2006
    A serial # of IC01+7 digits should make it an '01 … a good year for these, with better machines than the end of the run, they were discontinued in 2010 … I have used these on several bodies, including MIA Fenders
    pgnbstrd likes this.
  3. bluesfanjp

    bluesfanjp Supporting Member

    Nov 17, 2015
    payment pending
  4. bluesfanjp

    bluesfanjp Supporting Member

    Nov 17, 2015
    Not sold! back on the market
  5. PM sent.
  6. Primary

    Primary TB Assistant

    Here are some related products that TB members are talking about. Clicking on a product will take you to TB’s partner, Primary, where you can find links to TB discussions about these products.

    Dec 6, 2021

Share This Page