SWR 4x10 but with only 2 working speakers

[NeilJazz]

I have an opportunity to buy a this cab for a song. Apparently it is wired as 2 ohm. I have minimal knowledge on wiring or on how to wire this to run on a usual class D head.

Question is, is this a good starting cab? how hard is it to power a 2-ohm speaker setup? Can I convert this so that it can be powered by a regular class D amp?

 

[pingvuiini]

Just be careful if you take off the grille. The bent side edges of the diamond shaped mesh are extremely sharp!

 

[abarson]

Save your money and don’t buy someone else’s garbage. All four matching speakers need to be mounted in the cabinet, otherwise the holes act like enormous ports and will sound awful.

 

[fdeck]

In addition to sounding awful, it will be quite delicate, and you might lose the remaining 2 drivers if you feed it with any appreciable power.

This is not a "starting" cab because it doesn't work as-is and involves too many unknowns to make it work.

 

[5StringBlues]

If they aren't paying you to haul it away it's overpriced.

 

[Pulverizor]

How much is it?
You might sell those drivers if they're good condition... but then you have to find four replacements.
Nah sounds like a hassle.

 

[Pocket Dave]

Buy it. If your basement floods, stack it under an actual working cab. That’s about the only real use you’ll ever get out of it.

 

[baxter_x]

Do not buy that thing. You should have it for free.
If I remember correctly, there are replacement speakers for the Goliath II and III and it's the eminence CA10.
However, I hope you know how to replace and dire speakers.