• TalkBass has been independent since 1998. Add your voice.
    Create a free account to reply to discussions, view embedded media, and browse with fewer display ads.
    Join freeLog in
    Want zero display ads or expanded classifieds tools? Compare plans.

Vintage Ampeg Head and Cab , 197?

Hey guys. Just purchased this rig from a gentlemen in Escondido CA. He said it was a '72 but wanted to see if you guys could see anything that might say different. Plays real nice other than one or two speakers might need to be serviced.
Let me know if you guys can tell me anything. Just from some lookin around, all the 6550's say GE on them, i see a couple GT's..

1c8848c8.jpg


63e67c23.jpg


b51a156f.jpg


9d27a440.jpg


bd3d6ae6.jpg


8ef2ffed.jpg


4f9bb9ab.jpg


2349b7d5.jpg
 
Probably a 74-75. Mine is a later 74 and the serial number is just a bit lower than yours. The graphics (square black lines) put it in the 72-75 range. If you've got GE 6550s in there you've got some of the best power tubes available for this amp. Congrats on the purchase.
 
The pots are a pain to get to as you have to pull out the preamp chasis and take off the panel and all that jazz. Even easier is to take off the cover over the PI/drive tubes on the power amp chasis and look at the codes on the large rectangular resistors. I think the code starts with 242 or 245 but it will be a 7 digit code the first three being the EIA code for the manufacturer (like I said I think these should be 242) the next two the year and the last two the week.
 
Thanks guys. Im not all that savy with pulling things off or sticking my hand in there/ nor knowing what a potentiometer is. But, ill learn quick. Ima take the head to amphole for a good once over and see what BOB says about her.
But I'll most likely need to get the cab to a place to repair the speaker(s) that crackle when the volume is increased to 9 o clock on the head and the bass is turned pretty much all the way. The crackle isnt BAD BAD to where all I have to do is turn down the bass a bit,but its gotta be 100%, you know! Anyone know a good spot?
 
FWIW I spent about $250 a few years ago for a matched set of GE 6550s. A few of them drifted so much the tech at TAD couldn't bias the amp properly. He replaced them with their own set of matched and tested Chinese tubes and it's been going great since. He marked the old ones' values and gave them back to me.

I can't imagine what whack price a matched set of 6 GEs would cost now.