Enjoy the benefits of a premium membership!
Upgrade Account
-
TalkBass has been independent since 1998. Add your voice.
Create a free account to reply to discussions, view embedded media, and browse with fewer display ads.
Join free Log in
Want zero display ads or expanded classifieds tools? Compare plans.
Where can one buy a 4 way Parallel Looper Pedal
- Thread starter nickpower
- Start date
Liking the sound of this.
I'm looking to upgrade from 2 parallel signals (LS-2) to 3. Can anyone confirm whether the wounded paw products could handle the following:
Attitude bass P p/up (highs) - roll of low end - split signal - compress one (always on clean) - other signal goes through switchable distortion.
Attitude bass woofer pickup (lows) - eq - compression - mix with other signals - output to amp
It seems that the Blender V3 should be able to take my P p.up, into the main input, roll of the low end with built in eq then split to A and B (compression in loop A and dist on loop B) and roll the clean volume right off?
But does the eq affect the loop channels or just the clean channel? I note you can send the clean channel to A. I'm guessing I's have to eq B via distortion.
I would then route my woofer (low) p/up directly into the return of channel C and adjust mix to taste. Will this work, or can the return not be used like this?
Lastly, would there be any advantages to the Ultra Blender / V4 for my purposes over this?
FYI, at the moment, my high output is running though eq to roll of low end, into compression, into OD/dist into LS2. Low output though eq (to tweak) into compression and other LS2 channel in A+B mix mode. If the LS2 could handle an always 2 always on channels and a switchable third, I'd be laughing.
I'm looking to upgrade from 2 parallel signals (LS-2) to 3. Can anyone confirm whether the wounded paw products could handle the following:
Attitude bass P p/up (highs) - roll of low end - split signal - compress one (always on clean) - other signal goes through switchable distortion.
Attitude bass woofer pickup (lows) - eq - compression - mix with other signals - output to amp
It seems that the Blender V3 should be able to take my P p.up, into the main input, roll of the low end with built in eq then split to A and B (compression in loop A and dist on loop B) and roll the clean volume right off?
But does the eq affect the loop channels or just the clean channel? I note you can send the clean channel to A. I'm guessing I's have to eq B via distortion.
I would then route my woofer (low) p/up directly into the return of channel C and adjust mix to taste. Will this work, or can the return not be used like this?
Lastly, would there be any advantages to the Ultra Blender / V4 for my purposes over this?
FYI, at the moment, my high output is running though eq to roll of low end, into compression, into OD/dist into LS2. Low output though eq (to tweak) into compression and other LS2 channel in A+B mix mode. If the LS2 could handle an always 2 always on channels and a switchable third, I'd be laughing.
