Tons of power, and if you're looking you know these are bullet proof!
I initially purchased this for a backup, but I now use it in frequent rotation at church. The cab I use it with requires a 2 ohm load, I currently have 3 different amps that can handle this cabinet, so one of them has to go.
I've listed some of the specs below. One major plus is that it handles loads 2 ohms (and under) in the bridged mono mode, so it can handle multiple cabs if you need to.
The six space rolling SKB case is very nice (model # SKBR6W). If you take notice, I fabricated a heavy duty support system for the rear of the amp using commercial grade heavy gage angle iron. This, along with the vented grill and 1x aluminum spacer in front prevents this case from flexing when moving it around.
Other rack gear is not included, but the aluminum brace and the rear vent port are.
I would prefer a local sale, and would drive a reasonable distance to meet up. If you want it shipped, I'll get some quotes and shipping would be the buyer's responsibility.
PayPal preferred.
Specifications:
Output power:
1100W continuous @2 Ohm 20Hz-20kHz
800W continuous @4 Ohm 20Hz-20kHz
520W continuous @8 Ohm 20Hz-20kHz
(Bridge mono) 1650W continuous @8 Ohms 20-20kHz
Frequency response: 20hz - 20kHz ±0.1dB @1W Phase response: ±10° from 10Hz - 20kHz @1W Signal to Noise Ratio: >105dB 20Hz - 20kHz below rated output at 26dB gain THD: <0.05% from 20Hz to 1kHz and increasing linearly to <0.1% at 20kHz, delivering full rated power into 8 Ohms per channel IM Distortion: <0.05% from 10mW to full rated output at 26dB gain Damping factor: >1000 from 10Hz to 400Hz Slew rate: >13 volts per microsecond (stereo) Voltage gain: 20:1 ±3% or 26 dB ±0.25dB Mains power: 100/120/220/230/240 VAC 50/60Hz Dimensions: 2u standard rack mount x 406mm deep Weight: 23.5kg/51lbs.
