- Dec 20, 2004
- 4,267
- 2,481
- Disclosures
- Player-Builder-Founder: Honey Badger Pickups & Regenerate Guitar Works
to date if a bass I was building needed a pickguard, it was always a P-bass, J-bass, or MM-bass type job ... until now. For a project I'm working I needed to create a custom pickguard, and here's what's gone down
I first created a full-scale pattern with card stock so I could easily work out the styling details. Once my client and I were both satisfied, I created a wooden template from the card stock pattern.
and gave it a test fit
This template was then utilized to route a piece of .090" black matte vinyl making use of a 3/8" x 3/4" flush trim bit. Here's the results prior to finish sanding the edges and removing it from the template
This is a relatively simple job to do once you have a good fitting template. The most difficult part was getting all of the curves to flow smoothly, and to get that '51 Tele P vibe in a custom guard.
all the best,
R
I first created a full-scale pattern with card stock so I could easily work out the styling details. Once my client and I were both satisfied, I created a wooden template from the card stock pattern.
and gave it a test fit
This template was then utilized to route a piece of .090" black matte vinyl making use of a 3/8" x 3/4" flush trim bit. Here's the results prior to finish sanding the edges and removing it from the template
This is a relatively simple job to do once you have a good fitting template. The most difficult part was getting all of the curves to flow smoothly, and to get that '51 Tele P vibe in a custom guard.
all the best,
R
