Recent content by Domz

whoops! lol :doublefacepalm:

pretty sure those are lefty models. look at the logos

^^ this

Thanks gents!

the bass measures 34" from nut to bridge saddles the strings are for 32-34"

Hello all, I am about to install Rotosound Tru Bass (RB 88LD) strings but I am concerned about the length of the E string. This is where it sits.... looks to be too long Will this be a problem? The other strings seem to have enough silk wrap between the nut and the tuner...

ahhh ok... thank you very much for taking the time to help! I have copper shielding left over so ill go that route.

I get some resistance but if I dont get anything on continuity I dont see how it can be conductive. The cavitys of my jazz bass are copper shielded and I was told to connect them together with a ground wire. I get continuity when I touch the probes to the seperate cavitys. Shouldnt that...

thats what I figured but I checked continuity with my multimeter and got nothing. Does the paint go bad with time?

I am changing the pickups out on my Fender Prophecy II and when I removed the originals I found a ground wire screwed into the body under each. The P pickup ground was soldered to the one on the left and the one on the right was just sitting under the J pickup. I checked with a multimeter to...

I think a knot is just a poor choice in wood selection.

Nice

I can open my prophecy up and trace the wires for you if that helps

I was wondering about old english.... Does anyone else use it?

Sorry for the misunderstanding. Correct me if I am wrong but what Walter is saying is to just push down on the strings at the nut and saddle points to essentially bend the string straight?