Recent content by Foz

Might could be a blown cap I suppose.

It is possible, but if running a bass through the cab and all is properly wired [including the pad] that horn typically is not working very hard. Absent evidence of a very obnoxious HF event I'd reckon it more likely you have a loose wire, a cold solder joint, a bad cable, a weak bass battery, a...

Nah... A PA stack/cab or a bass rig stack/cab cost the same given equal abilities. This is because they are the same thing. IMO just about any less than FRFR PA cab you consider "good enough" can be replaced by a functionally equivalent less than FRFR bass cab for similar cost. There is no...

A full range flat response bass cab is a PA cab - and vice versa. I have used a greenboy 1515/66 +1 in both roles = works a treat.

I'd lay foam on the port shelf - screw the boards down - and hot glue all the components. The inside of that cab gets raucous - anything left loose will come apart

could be one of the wire leads touching the cone

Another TB happy ending.

Krylon

42

Here's a couple https://www.speakerhardware.com/prodimages/fearful%20plans/15+6.zip https://www.speakerhardware.com/prodimages/fearful%20plans/12+6.zip This web store also sells parts for the build... fEARful DIY Speaker Kits for Bass Guitar

Why not use pedals to high-pass the guitar channel signal and add distortion? Wouldn't that make finding a cheap head for the guitar channel a breeze as it removes the requirement the the new head has to handle the low freq. output of the bass and then also provide the best solution for the...

air compressor

Two words... Great Stuff

I fail to see how any of these aspirations is advanced by have a "stereo" rig = having an additional acoustic output source doesn't advance any of your stated goals. Why not add a small mixer and do all your diddling with "colouring"/"mix balance"/et cetera through that unit... then use the...

Who sez I aint?