Recent content by JohnnyC

Here's our playlist: Link Removed Some stuff everyone else does, some stuff nobody else does. Pretty much just classic rock.

I alway setup stage left and I wear an earplug in my right ear only. I also set my monitor up angled in from the left side so I can hear everything I need to with my left ear.

I just put a Babicz bridge on mine, dropped right in - no problem.

I've been giggin' with the 1001RBII through an Ampeg 6x10HLF for the past 3 years - couldn't be happier. 700W through a 6x10 - I don't think I've been past 6 or 7 under any circumstances - IT'S FREAKIN' LOUD! No worries in that department, your drummer and guitar player will throw you out of...

For what it's worth, I have a 1001-RBII and run it through an Ampeg 6x10 cab. I tried a lot of different amps/cabs before I decided on this. I have plenty of power if I need it for bigger venues/outdoor settings and it provides enough versatility to get either warm/clean sounds or really...

I just fninished Phase 1 of my project as follows: Bass = 2006 Fender Aerodyne Jazz PUPS = Seymour Duncan QP's (both neck and bridge) Neck VOL = 500K linear taper CTS POT Bridge VOL = 500K linear taper CTS POT TONE push = 250K audio taper CTS POT pull = kill Bridge = Babicz FCH...

uh...cuz I'm a dumbass and didn't think of doing it that way and I have to make it way more complicated than it needs to be. ;) Brilliant, elegant, simple. THANK YOU! That's why I posted the question in the first place.

Here's the genesis of this whole thing.... I have a PJ bass that is rear routed (no pickguard or cover plate). I've decided to upgrade with the SD QP's and I started thinking of how I use the current VVT controls. Also, the one feature I'd really like to add is a kill switch but I don't...

Hmmm...not sure about the "most" statement but I hear ya and agree, why not just use a 5-way and have the additional option? I think will probably go that route, thanks!

After reading a lot of threads here I think I have decided on the following configuration for my PJ re-wire project: SD QP's (both neck and bridge) Control 1 = Neck VOL 500K Control 2 = Bridge VOL 500K Control 3 = 4/way rotary switch Sw Pos 1 = Neck pup Sw Pos 2 = Both in series Sw...