Recent content by Musheenhed

No but I'm working one it

I am as qualified as a tube amp builder, and an electronics hobbyist for 40+ years. The only thing is, I loathe doing solder rework on surface mount components. They are truly a lesson in frustration management. Anyone know where I can find a schematic? That would help loads!

No. I can't afford to pay for repairs right now.

So my minimega died half way through rehearsal last night after a slight burning smell. Turned off the power and pulled the fuse. Looked good and tested good. No idea where to go from here. I'm bummed because now I have to lug around my great sounding SVT4-PRO again. I guess I did say I needed...

Actually I do custom inlay and led side marker light install. I am doing a led install on a Spector right now. If it's a neck through body it can't be done without re-painting the bass. I only do led installs on natural maple bolt on necks.

I play in a Judas priest tribute band and looking for the right bass to complete the look. Anyone know of any gloss black euros or ns-2 or cr-4 for sale? I'd like to have an Ian Hill signature model as well. I'm currently playing a matte black rebop deluxe and it's not quite right according to...

I make my own and have a spare roughed out. I could be persuaded to make one I you would like, just need accurate width and depth measurements. With calipers or better. You would have to finish filing the string grooves to the proper depth for your bass or have your local luthier do it.

What is the Impedance when using both speaker output jacks? I have 4, 8 ohm cabinets. I would like to run each output into a 2x10 cabinet and from the out jack on each 2x10 into 8 ohm 1x15 cabinets. My question is what would impedance be with this configuration? I measured the Impedance of each...

This probably isn't the right place for this but can someone tell me what terminals the black and white wires go to on a standard Neutrik connector for a Peavey Minimega? I have some older speaker cables that have standard 1/4 inch plugs that I was going to wire up with the Neutriks

I had similar problem with peak light staying on. I would completely loose all sound when this happened. I removed all of the circuit boards and with my magnifying visor examined each solder joint. I re-soldered 3 obviously compromised joints but still had the problem. After rolling in a dozen...

I don't know about you all, but something has always bothered me about American and Czech made Spectors. Even the Korean NS-2A models. Actually now That I think about it... It's the curved back models...That is, the way the electronics cavity covers are not counter sunk flush with the body but...

It's a custom thumbrest I machined from aircraft aluminum that utilizes the original pickup height adjusting screws for mounting. I didn't want any extra holes in the body.

It's a q4 pro Korean bolt on with factory EMGHZ BTS system.

No it's an inlay. I do custom work.