Recent content by stshipley

I prefer 1.5" - But I'd happily buy either one

Success!!!! Thank you @cashmoneywill !!

I would like to replace the push pull with a standard 250k pot. Can you show me how you have yours wired to connect to the three way switch, or just describe which wire goes where on the replacement pot? Thanks in advance!

I got a Vintage Burst Sterling SS Stingray new in the box from GC in January last year. I was pretty pumped to get a shorty to replace my Ray34ca. Straight out of the box it had some challenges to overcome. The fretwork was the worst I've ever seen in a brand new bass. Easily solved with a...

Hey everyone, I recently took my EMG GZR PJ pickups out of my 2018 Fender PJ Mustang to put in another bass I was using more frequently, and I've been trying to get the original pickups back in place. I have gone through a number of permutations of wiring but no matter what I do, I can't get...

Ok, soliciting advice here. I got a Vintage Burst SBMM short scale back in January. It’s definitely fun to play. I ditched my Ray34ca to get the short scale. The problem that when I play it with my band, I get a sea of low end and no highs. Like none. I didn’t have this problem with the...

PM'ing you for sale

I love that strategy! My wife however . . . . Actually for bigger needs, I'm covered with mw SWR Goliath II. It's never failed me, but it's totally non-workable for small spaces and it's a pain to move around (90lbs!!!) I will have to thank hard on the C4 vs the Cab-27. I'm leaning towards...

Thanks to all for your helpful comments. I think I need to err on the safe side and go with the Rumble + Cab-27 for this weekends gig, but then I probably will be done with the Rumble, maybe for good. The sound of the Rumble 15" is very devoid of higher mids. The BQ500 + the Cab-27 makes my...

BlueTalon, That's what I have been doing, but it does take up a bit more space, and more importantly, it covers the Rumble Amp controls. In a more expansive setting I could walk around and change them easily - in close quarters it requires some contortions to access, if you catch my drift.

Hello all, I have been using a Fender Rumble 200 for practice and adding my PJB Cab-27 to it for shows, since the 200 will run an extension cabinet. The vast number of shows I play are without PA support for bass. I recently got a TC-Electronic BQ500 and I am wondering if I can ditch the...

I'll take one of your hands if you still have one

I have this bass and verify it's a gem. GLWTS!

What is the nut width?

Is this still available?