rotary switch

I've got Nordstrand Big Blades i want to wire Bridge - Both Parallel - Both Series - Neck, on a 4-way rotary switch. Can anyone point me to a diagram for the witing?

Anyone have ideas for a 4way rotary switch that Enables: 1)parallel bridge pick up/parallel mid pick up 2)SERIES bridge pick up/parallel mid pick up 3)parallel bridge pick up/SERIES mid pick up 4)SERIES bridge pick up/SERIES mid pick up I confess I'm finding this a bit difficult myself...

So I've got an old Stingray Sub I've modded to hell and back. Its pretty beat up and was bought from a Cashconverters (Pawnshop) for a steal here in the UK many years ago. Previous mods have included: - Replacing pickup with Kent Armstrong - Wiring the pickup passive in series - Splitting out...

Hello everybody. I have a Squier Bronco and I'm going to replace the stock single coil pickup with a Strat-sized dual-rail humbucker. I still don't know if I'm going for a generic pickup from eBay, a Dimarzio or a Seymour Duncan but they all have 5 wires (2x start, 2x finish, 1x bare ground)...

Question regarding wiring new pickups: I just bought the active EMG David Ellefson Soapbar solderless kit to install into an old Ibanez PL5050 but there are 4 pots (blend, volume, 2 tone) to replace and the kit only requires 3 (VVT) even though it comes with 4 (VVTT pots) if needed. I’d like...

I'm wondering if there is anyone here who can help me with figuring this out. My current setup is Neck and Bridge humbuckers go into a balance/blend which goes into active EQ which then goes into Master volume with bridge grounded to the pot then output jack. I know the series/parallel switch...

Greetings! I've had a 74-75 Gibson Ripper for a little over a year now, and it played and functioned perfectly until recently. The issue that I have now is that out of the 4 positions on the rotary switch, only one gives me "full volume". What I mean by that is that while positions 1, 2 and 4...