A wiring conversion for someone quick

[Groovin_Joe]

Hi... I am building a custom bass and it has come time to wire it. I am installing 1 Basslines SMB-4a Musicman replacement. I want to wire it with the 3 way blade switch (series/split/parallel) then into a master volume and a tone knob. I have a schematic for it... kinda... I have looked at the seymour duncan site and it isn't helping. I was hoping if someone could do up one for me... I have this diagram for a on/on/on switch that does it. I just don't know how to transfer it to a 3-way blade switch...

********* 0 0 <bridged to white
***WHITE---0 0----RED
GRN&BARE----0 0------BLACK
**********| |
****GROUND OUTPUT

Please ignore the stars... talkbass wouldn't use the spaces i put and the 'picture' was all off

Hope this makes sense. I have searched and searched.

Thank you to all who can help.

Adam

 

[robert43]

Hi next time try the S & D website great web site why quick any way here it is [Invalid or Expired Link Removed]

 

[Groovin_Joe]

I did look there and none of them are what I want. Also i have tried it the way they say on that site and it didn't work.

that diagram that you linked to is the one I want to make into a 3 way blade switch... where the lugs are 2 rows of 4 lugs each. not straight 8 in a row.

Thanks though

 

[robert43]

Hi now I understand I dont have a 3 way switch like you said if you had a multi meter I could work it out . If you dont have a multi meter go to RS get a 9 volt battery snap 9 volt battery & a 9 /12 volt buzzer.
put the black - from the battery snap to the red + of the buzzer & tape. Then put the red of the battery to the black of the buzzer & it will make a noise.
If this works then email me & I will take you throught the rest


[email protected] Robert

 

[robert43]

Look what I have found

[Invalid or Expired Link Removed]

 

[Groovin_Joe]

I found that 3 way switch... it didn't work. I have looked through the entire site... NOTHING