1. Please take 30 seconds to register your free account to remove most ads, post topics, make friends, earn reward points at our store, and more!  

Acoustic B100 on Fender P bass... Settings help

Discussion in 'Amps and Cabs [BG]' started by cire113, Apr 5, 2009.


  1. cire113

    cire113

    Apr 25, 2008
    I am getting terrible muddy distortion on my fender p bass with my acoustic b100 amp..

    What is the relation between gain and volume?

    my settings are

    Gain 10 oclock

    Volume 12 oclock

    Frequency 12 oclock

    Low- 12 oclock

    Low- mid 12 oclock

    High- 1 oclock

    High-mid- 11 oclock


    I cant turn the low end higher because it starts to rumble terribly and im looking for a nice clean bass sound no distortion
     
  2. IIRC Gain controls the preamp and Volume controls the power amp. Have you tried lowering the Freq. knob back to 0?
     
  3. Mr.Joshua

    Mr.Joshua

    Nov 17, 2007
    Plano, TX
    I have a nice sound out of my Jazz and B100 with the following settings:

    Gain 10 am (less is better)
    Volume 2 pm
    Frequency 12 Noon
    Low 9 am
    Low-mid 10 am
    High-mid 10 am
    High 9 am

    Basically, set all of the levels below Noon, and dial them down from there. Then bring up the volume.

    I use the passive input, even though I use an active bass.

    MrJ
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.