Hi!
I just had my Bass with Barts M46CBC installed Aguillar OBP3 on it.
initially t had a vol ,vol pots & series/single coil switch.
the volume is moderate.
So my tech installed Aggie , with config as follows.
Vol , blend, mid(push pull), bass/treble stack,and uses the series/single coil switch as an active passive sw.
The problem is: the volume is passive mode and blend in centre is FAAAAR too low compared to active/aguilar pre on...in scales, I might say 1 : 5.
If blend is fully towrds neck or bridge pickup. then the difference is 4:5..
Is this normal? or should i go back to vol vol set up?
or should i use proper ON OFF switch..
ANy advise/suggestion are very much appreciated.
thanks
regards
adrian
I just had my Bass with Barts M46CBC installed Aguillar OBP3 on it.
initially t had a vol ,vol pots & series/single coil switch.
the volume is moderate.
So my tech installed Aggie , with config as follows.
Vol , blend, mid(push pull), bass/treble stack,and uses the series/single coil switch as an active passive sw.
The problem is: the volume is passive mode and blend in centre is FAAAAR too low compared to active/aguilar pre on...in scales, I might say 1 : 5.
If blend is fully towrds neck or bridge pickup. then the difference is 4:5..
Is this normal? or should i go back to vol vol set up?
or should i use proper ON OFF switch..
ANy advise/suggestion are very much appreciated.
thanks
regards
adrian
