Hey everyone.
I have a line 6 bass pod XT. I recently found an old Peavey switch board PMC 110 i think is what it is. But its just connected VIA MIDI.
Basically i got it to work twice, and now i cant figure out why the board wont.
The operation is simple, both devices off > turn on pod > turn on board > select 01, and then 01 (the buttons on the board)
Both devices boot up just fine, its the peavey PCM110 decides to go into a stand alone mode..
Obviously im not using "Certified compatible" equipment so im not expecting it to work. I was just wondering if anyone Has used this before or soemthing like this and has any 2 cents they can add.
I have a line 6 bass pod XT. I recently found an old Peavey switch board PMC 110 i think is what it is. But its just connected VIA MIDI.
Basically i got it to work twice, and now i cant figure out why the board wont.
The operation is simple, both devices off > turn on pod > turn on board > select 01, and then 01 (the buttons on the board)
Both devices boot up just fine, its the peavey PCM110 decides to go into a stand alone mode..
Obviously im not using "Certified compatible" equipment so im not expecting it to work. I was just wondering if anyone Has used this before or soemthing like this and has any 2 cents they can add.
