In my active bass, the negative lead came out of the snap connector. I purchased new ones from the shack, and the negative lead is not long enough to get to the output Jack, which is where it's supposed to go. Can I just solder the wires together and electrical tape them together?
Enjoy the benefits of a premium membership!
Upgrade Account
-
TalkBass has been independent since 1998. Add your voice.
Create a free account to reply to discussions, view embedded media, and browse with fewer display ads.
Join free Log in
Want zero display ads or expanded classifieds tools? Compare plans.
Battery problems
- Thread starter GnRDuff1
- Start date
Just don't make it a big gobby joint. Heavy, over large solder joints will act like an inline resistor and can generate heat in a system so make it some clean butt joints and use shrink. It's one and done, no coming lose (or off) in the future and is available in a wide range of sizes at your local hobby shop.
