1. Please take 30 seconds to register your free account to remove most ads, post topics, make friends, earn reward points at our store, and more!  

Harke Amp rack Mounting

Discussion in 'Amps and Cabs [BG]' started by Scootr117, Mar 17, 2009.

  1. Scootr117


    Mar 11, 2009
    New member here.....I just bought a HA4000 amp and I would like to mount it in a small composite rack case. The problem is there are no ears (tabs) to bolt it up. Can someone point me in the right direction to buy the needed brackets or if it is even possible to do this...

  2. anderbass


    Dec 20, 2005
    Phoenix. Az.
    Heres the link to your rack ears on the Hartke/Samson web site: http://www.samsontech.com/products/partaccview.cfm?partoraccsID=1503
    Unfortunately they seem to be out of stock.
    You might try contacting Hartke about this:
    hartke@samsontech.com <hartke@samsontech.com>

    I searched the net for any other source and didnt find any.

    Rack ears are simply a flat piece of metal with a bend and the corect holes drilled. If your handy meyby you could make your own or adapt some ears from most any other 2 space amp. A sheet metal shop could easly make some for you. (just bring your amp and rack)

    Another option here is simply using a rack shelf. here's a bunch of those:
    Note: sometimes using a rack shelf ends up using a bit of aditional space in your rack...
  3. Scootr117


    Mar 11, 2009
    Thanks.....I didn't know about the shelves....I may need to go that route. I can fab some tabs up...I was concerned with the small (4-40?) threads on the side of the amp...I was thinking they are normally 8-32 screws.

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.