1. Please take 30 seconds to register your free account to remove most ads, post topics, make friends, earn reward points at our store, and more!  

Homemade bass cab help?

Discussion in 'Amps and Cabs [BG]' started by Barcode31, Apr 10, 2010.


  1. Barcode31

    Barcode31

    May 16, 2009
    Arkansas
    I have a 15 inch Eminence speaker with 300 watts 8 ohms, that I built a box for. I just bought a Behringer Ultrabass BX4500H. It works pretty good rattles the room I'm in, but their are three outputs on the amp. 1 is a 450 watt with 4 ohms. Then there is 2 with 250 watts to 8 ohms. Should I bridge the two with a splitter into my one cab input?
     
  2. Jaco who?

    Jaco who?

    May 20, 2008
    No. You just have a choice of two 1/4" and one speakon connector, all usable as you wish for a minimum 4Ω load. You will not actually be "bridging" anything, at best it will make no difference at all, at worst you'll bugger it up real good.

    http://www.behringer.com/EN/images/lightboxphotos/BX4500H_P0362_Rear_XXL.jpg

    What can I say, I'd rather do this than my #^%&@ taxes.
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.