• TalkBass has been independent since 1998. Add your voice.
    Create a free account to reply to discussions, view embedded media, and browse with fewer display ads.
    Join freeLog in
    Want zero display ads or expanded classifieds tools? Compare plans.

Mark Bass Ohm question

I looked around the faqs at the top of this forum, but I couldn’t find an answer. I was hoping someone can answer this for me. I have a Mark Bass Little Mark II and a
Mark Bass TRV102P-4ohm cab. If I want to add another cabinet (15”), does it need to be 4 ohm or can it be an 8 ohm cab?
If your 102P is 4 ohm, you're all done. That is you cannot add anything else lest you dip below the 4 ohm minimum of the LittleMark.
 
I hate to disagree with everyone, but sure you can. You'd just have to wire the second cab in series instead of parallel.

Your amp is rated at: 300W RMS @ 8 ohm, 500W RMS @ 4 ohm

The amp would see 8ohm with two 4ohm series wired cabs. 8ohm is a higher impedance/lower load (less power). So you'll be fine. Shouldn't be that hard to do.
 
Last edited:
  • Like
Reactions: brokenstoned
I hate to disagree with everyone, but sure you can. You'd just have to wire the second cab in series instead of parallel.

Your amp is rated at: 300W RMS @ 8 ohm, 500W RMS @ 4 ohm

The amp would see 8ohm with two 4ohm series wired cabs. 8ohm is a higher impedance/lower load (less power). So you'll be fine. Shouldn't be that hard to do.
Seems like a senseless road to go down. Use 2 cabs and not realize the headroom of the amp? Better he offs the 4 ohm cab and buys two 8ohm units.