NAD!! Rack content

[Boostedrex]

So I received the last piece of the "puzzle" yesterday afternoon. All 4 pieces of this setup are new to me so I felt the need to share. I'd like to thank Ukiah bass, Zooberwerx, and mjcoderre for the good deals I scored on gear from them. Also all great guys to deal with! Well, here it is:

Korg DTR1000 rack tuner
Yamaha PB-1 pre
Crown XLS 402
SKB ATA 4U case

This will be powering my DIY cab which is almost finished. It's a bit of a take on the fEarFul design just using different drivers and a few tweaks. A pair of B&C 15NW100's and a horn loaded driver to handle the high end. Though the horn driver will be on a removable baffle so I can test out a dedicated midrange in it's place. I'll post pics of that cab once it's finished. Thanks everyone for looking.

Zach

 

[mikeddd]

Congrats on a nice rack setup. How are you plugging everything in? Is there a power strip mounted in the back? Make sure you post pics of the cab...heck, you should've made a build thread.

 

[Boostedrex]

There will be a power strip in the back of the rack case. And while I'm experimenting between horn loaded drivers and midranges I'll run bi-amp using the PB-1's X-over network. After I figure out which I prefer I'll build a passive and then bridge the XLS 402 into an 8 ohm mono load.

And the build thread will be coming Mikeddd. I just usually wait to do a build thread until I'm finished. That way I can post all of the pics at once. I've done some initial testing with just the pair of 15's and I LOVE the way they sound.

Zach

 

[mikeddd]

Dual 15's=thump city! Can't wait to see the build thread. Good luck!