• TalkBass has been independent since 1998. Add your voice.
    Create a free account to reply to discussions, view embedded media, and browse with fewer display ads.
    Join freeLog in
    Want zero display ads or expanded classifieds tools? Compare plans.

PA Speaker Specs

Based upon the following specs, assuming price was the same, which would be the best bang for the buck for these PA speakers?

Speaker A:


* 12" Woofer
* 10" x 4" horn
* (3) 3" Piezo tweeters
* 100W RMS
* 400 watts peak power
* Frequency response: 50 Hz to 20 kHz
* Push button connectors & dual 1/4" input jacks
* 8 ohms impedance
* Recessed side handles
* Carpeted passive loudspeaker

Speaker B:


* 12" woofer
* 11" x 5" double piezo horn
* High-temperature voice coil
* 100 watts RMS trapezoid speaker
* 400 watts peak power
* Frequency response: 50Hz to 20kHz
* Banana & dual 1/4" input jacks
* 8 ohms impedance
* Recessed side handles
* Carpeted passive loudspeaker

Speaker C:

# 12" woofer for deep bass tones
# 6" x 12" horn for shimmering highs
# Specially voiced internal crossover provides superb separation of frequencies
# Recessed handle
# 1-3/8" polemount
* 100W RMS handling
* 200W peak
 
Jack, the reason piezos are crap for PA speakers is that they don't reach down very far in the frequency spectrum. This leaves a big hole in the sound reproduction of the speaker cabinet right in the mid frequencies which are very important for vocals.

Derek
 
The 100 watt speakers are sort of scary. There are a lot of good speakers out there for reasonable prices that are rated at 400 or 600watts. Peavy PR15s are a good 2-way with a 15 and a horn in each, and we paid $200 each. I'd be afaid of blowing 100watt speakers if you drove them hard. We use 6 2-way mains, and 2 subs, and get fine frequency response. I agree, piezos just aren't great for vocals.