Signal Chain?

[Caius1991]

I know there are a few threads about this, but im unsure, so i was hoping for some advice here

so far i run

Bass >
KORG pitch black tuner
Behringer Limiter Enhancer (waiting to buy upgrade) >
Boss ODB-3 Bass Overdrive >
Boss CEB-3 Bass Chorus >
Boss NS-2 Noise Suppressor >
Amp

I was wondering if this was the optimum order to put them in, as i find my ODB-3 has a nasty habit of making screeching noises when i turn it on in the chain sometimes, maybe i have the noise suppressor in the wrong part, but any help is appreciated, I run an active Traben bass normally through a Hartke head and cabinet half stack both 500w if that helps

 

[RickenBoogie]

I would lose the noise gate first. Then , be sure all pedals are running on clean isolated power. From there, your order seems fine, but there's no right or wrong way to do it, just so long as you're happy with the results.

 

[Caius1991]

So like buy a power-brick or something, because honestly i used a cheap daisy chain power supply i got with a gator pedalboard i got

 

[MR PC]

+1 lose the noise supressor, and just put the tuner at the end of the chain

 

[bassbyblaine]

@MR_PC is it always best to have the tuner at the end of a chain?

 

[RickenBoogie]

No, it's debatable. I like my tuner FIRST, so it gets a clean signal, and mutes the whole board when on. The daisy-chain power supply *could* be making noise in your signal. Best advice, remove the noise makers, instead of covering it up with a gate.