• TalkBass has been independent since 1998. Add your voice.
    Create a free account to reply to discussions, view embedded media, and browse with fewer display ads.
    Join freeLog in
    Want zero display ads or expanded classifieds tools? Compare plans.

Svt vr problem tone

Ciao a tutti. Ho sostituito i finali del mio svt vr e dopo circa tre mesi di lavoro il suono è cambiato nel giro di pochi giorni. Ora suona piatto e privo di calore. Ho sostituito una valvola del preamplificatore perché è microfonica (v4) ed è migliorata ma sembra ancora fredda. Ho deciso di revisionarla completamente (tranne i finali ovviamente). Ne ho ordinati alcuni tad. Spero che funzioni altrimenti potrebbe essere un brutto finale? Grazie per il consiglio.
 
I don't speak Italian. I hope Google Translate hasn't led me too far astray.

I understand that you replaced the power tubes / valves on your SVT VR, but after three months it suddenly stopped sounding good.

The SVT operates its output tubes under very stressful conditions. It is possible that one of them failed. The first thing to do is to follow the instructions in the Owner's Manual for checking the bias - there should be LED indicator lights on the back of the amplifier. If the bias can't be adjusted correctly, a tube has probably failed and needs to be replaced.

Google Translate:

Non parlo italiano. Spero che Google Translate non mi abbia portato troppo fuori strada.

Ho capito che hai sostituito le valvole/i tubi di potenza del tuo SVT VR, ma dopo tre mesi improvvisamente ha smesso di suonare bene.

L'SVT fa funzionare i suoi tubi di uscita in condizioni di forte stress. È possibile che uno di essi si sia guastato. La prima cosa da fare è seguire le istruzioni nel Manuale dell'utente per controllare il bias: dovrebbero esserci delle spie LED sul retro dell'amplificatore. Se il bias non può essere regolato correttamente, probabilmente un tubo si è guastato e deve essere sostituito.
 
il bias è regolare e le valvole di potenza sono state sostituite da un centro Ampeg qualificato che ha tenuto l'amplificatore per quattro mesi solo per sostituire le valvole, non voglio riportare di nuovo l'amplificatore lì. comunque grazie per le risposte
 
the bias is fine and the power tubes were replaced by a qualified Ampeg center who kept the amp for four months just to replace the tubes, I don't want to take the amp back there again. anyway thanks for the answers
Then you need to find another QUALIFIED service tech to work on it. It's possible that you have a defective tube, or something else failed since the previous service.

There have been difficulties obtaining some tube types over the past 5 years, including some that are used in the SVT's. It may be that your tech was waiting for higher quality screened and matched power tubes rather than settling on something substandard. It's not always the tech's fault, and sometimes it's an honest mistake or simply a failed part.
 
Non fraintendetemi "cavallo invecchiato". Il tecnico a cui ho portato la testa è l'unico di cui mi fido. Porto lì la mia attrezzatura da circa vent'anni. Sono pieni di lavoro e i loro tempi di consegna sono questi. Cercherò di sostituire le valvole del preamplificatore perché sono originali, se non lo sono la riporterò al tecnico. Grazie
 
È importante cambiare entrambi i tubi nel telaio superiore. Inoltre, assicurati che siano stati installati i piccoli tubi corretti, due 12AU7 e un 12AX7 nella parte inferiore. Forse le posizioni erano confuse.
 
Last edited:
As the owner of an SVT, should I buy a set of tubes in advance just in case things get worse?
I wouldn't, we don't know what may happen... plus there's no warranty on tubes that have been stored and not used.