Winter Build Off 2023 - Yve

[joover]

It's an interesting idea. Do you mean slight bevel to remove the problem (e.g. 1/8") or bevel from top to bottom surfaces at a sharp angle? Any chance you have a photo of a beveled headstock?

I should have clarified that damage is at the bottom surface. I've been thinking about gluing in veneer at the bottom of the headstock. The crazy idea was to use "negative" of the truss rod cover at the bottom. Truss rod cover is in blue below, it covers entire width of the nut.

 

[lbridenstine]

I do a small bevel on mine.

I didn't realize it was on the bottom on yours, but I think that doing both a top and bottom bevel would look good.

 

[joover]

I've made a decision to focus on SBO'23 project until the deadline: SBO 23 - Picobass V revival

Meanwhile, I've made some progress and glued up top plates