Wireless channel switcher?

[Down_Low]

My amp has two channels - a clean and an over drive channel, which is switchable with a footswitch. But the footswitch means I need to run an extra cable to my pedalboard, and it’s not an overly long cable.

Does anyone know if a wireless or Bluetooth channel switch exists? So a small stompbox on my pedalboard, and a receiver to plug into the back of the amp?

 

[bassbrad]

What type cable and connector? Probably be better off having a tech tire up an extension. Wireless switchers are not terribly reliable or terribly expensive and Bluetooth will have a latency delay of 2-3 seconds a lifetime in love performance.

 

[Rocksolid]

Come on mate! Just run the cable!!

 

[Jazz Ad]

Audio Technica System 10 is the only device I know that allows it and there will be lag. It sounds like more trouble than it's worth. Maintenance for battery, running 3 cables instead of 1 and still getting lag.

 

[Down_Low]

Come on mate! Just run the cable!!

Easier said than done on a big stage, the cable isn’t overly long! By the sounds of it there’s no good options, so guess I keep using a drive pedal instead.

Thanks for the responses (except for Steve! That pickup arrived too thanks mate. Haven’t had a chance to install it yet though).

 

[Rocksolid]

Easier said than done on a big stage, the cable isn’t overly long! By the sounds of it there’s no good options, so guess I keep using a drive pedal instead.

Thanks for the responses (except for Steve! That pickup arrived too thanks mate. Haven’t had a chance to install it yet though).

OK... I'll be helpful. I don't use the standard footswitch, I use a Boss FS-5L Latching Footswitch, and a long, standard cheap ass cable. The standard one is a PitA...
Does that help?

 

[Down_Low]

OK... I'll be helpful. I don't use the standard footswitch, I use a Boss FS-5L Latching Footswitch, and a long, standard cheap ass cable. The standard one is a PitA...
Does that help?

Somewhat, thanks mate.