Recent content by Wayne Train

  1. W

    Any info on Sound Town ST-UPDM7500?

    Hi Fran, this is probably too late but here goes. I bought 4 of these from a friend that had them for 2 months, never used them. But I did, I hooked them up to my club rig, 2 subs on one, 2 mains on one, 4 monitor mixes from the other two. They worked for a few hours, the sound was not crisp and...
  2. W

    DBX 160A vs cheaper DBX rackmount - quality????

    I just bought a 266xl for my bass rig. Can anybody suggest the settings to make it behave like a 160A? If I leave all the knobs at unity and press auto, will that do it?
  3. W

    NEW Line6 G30 wireless - REVIEW !!!!

    I've had my G30 wireless now for 6 four set gigs. I've only used two sets of Alkaline batteries though they would have probably lasted one more gig each. I've gotten lots of compliments on the big deep rich sound and I'm pleased also. I've had Shure and AKG wireless before but they were way weak...
  4. W

    Making a you tube video....

    This is another vid of the same setup with out any processing.
  5. W

    Making a you tube video....

    I have been using a cheap camera with a stereo mic input and a cheap stereo mic to record bands and other events. Here is one I took of my band. I imported the video into Presonus Studio One, extracted the audio, and put a couple of multiband EQ's and compressors and a limiter (all Presonus)...
  6. W

    Does Sansamp + power amp = good rig? HELP!

    You mentioned an effects loop for adding an EQ. I've got a SansAmp BDDI into a Hartke 3500 which has 7 band EQ, real tube preamp plus a solid state (transister) preamp, a compressor, tone controls, 350 watts into 4 ohms. For about $350 for the Hartke, it would be hard to buy an amp and all that...
  7. W

    Need some advice.. cab building and speaker choices.

    Magneto, I've built a lot and bought a lot of bass and PA cabs. Size, weight, cost and sound quality are the biggest concerns you WILL have. You can indulge yourself with trying to build something that will ultimately come up short or just get what you really need. I suggest what I finally ended...
  8. W

    Ampeg SVT610HLF.

    I've had my 610 for about three years and I do sometimes play ridiculously loud. Like outside concerts with stupid loud guitars. Granted, I play a 4 string but dang, loud. I've never had it fart or distort or breakup or any of that crap. Like the poster said before, haters probably have never...
  9. W

    BC Rich MEGATHREAD

    I've had my (83?) Eagle since the early 90's. Daily driver. Couldn't do without it. Wayne Phillips's Photos | Facebook
  10. W

    BC Rich Basses

    I've had a lot of basses since 1967 and I've had this '83 passive Eagle NJ NT since the early 90's. Now it's my only one and I play out constantly. There is no neck dive at all. Whenever I let other people play it (which is not very often) I get comments like it's the smoothest, easiest to fret...
  11. W

    BC Rich NJ Eagle Flies Again

    Here's two more pics. You can hear this bass on this song. Kodak Zi8 Night Time Soul Street Missionaries-Down - YouTube
  12. W

    BC Rich NJ Eagle Flies Again

    Hi klk999. Great job on the Eagle. The fret buzz could be a bulge in the neck around the 3rd fret. A little sanding on the fret board and a new fret job will work wonders. I bought my '83 in the early 90's for $400 with a non BC Rich hardshell case. Since then it's been my daily driver with...
  13. W

    Ampeg PR 410 HLF versus Ampeg SVT 610 HLF

    Thanks Kosmicwizard. I think you're right. I've got my eye on a vintage 4 string Thumb NT and an RBI.
  14. W

    Is it worth adding a 12" sub to a 4x10" setup?

    Hi Crispygoat, one of my setups is a 12" EV SRO in a cab I built. It sounds great but it won't keep up with some of the line ups I play with but for some small rooms it works better (more definition) than a larger cabinet. I tried hooking up an 18" EV sugar scoop with and without an Xover. It...