BAII height adjustment screws

[megadan]

What's up with these? I have a full set of allen keys and the tiniest one doesn't fit. If there was a smaller allen key it looks like it would snap like a toothpick. Is there an official BAII allen key/hex wrench/screw driver? Why can't they use standard sized screws!

 

[Turnaround]

What's "standard"? Imperial? Metric? Welcome to the global marketplace.

 

[megadan]

I have an imperial and a metric set, but they're like... the same sizes! Just measured differently. At least, there's not one small enough on either set.

 

[Turnaround]

Sounds like it may be a .050 inch key. I've run into a few of those. Or a 1.5 mm. These are "standard" sizes, just not common.