BOSS GT-6B tone-Wah issues

[godzofthunder]

To anyone that can help.I have spent a good amount of time dialing in and tweaking a user patch.I wrote and saved the patch and banked it.
I like the tone I saved,however it completely changes when I engage the (bass wah) setting.It gets very thin and brashy-the low end frequencies are cancelled out.The EQ prior to this is set with the low frequencies saved.But when the wah gets clicked on the tone just completely loses the lows.Is there any way to save the tone and mix it in with the Bass Wah setting without the wah changing the tone? I tried the other wah settings-but it just doesn't have the "wah" sounding effect as much as the Bass wah setting does that I can control.The BOSS GT-10 does not have this issue...the tone and low-end never get lost.Any advice on the GT6B ?

 

[ga_edwards]

I believe you can set up a custom wah, that lets you fine the parameters of the wah. Changing the Q (width) might stop it sounding so thin, as well as changing the high low range.

Apparently the GT10 let's you mix in a parallel unaffected tone which prob stops it sounding so thin. The GT6B can't do this.

 

[godzofthunder]

Thank you-that helped.....but the GT-10B is the only answer-thanx-ga_edwards for taking a minute to reply back!