• TalkBass has been independent since 1998. Add your voice.
    Create a free account to reply to discussions, view embedded media, and browse with fewer display ads.
    Join freeLog in
    Want zero display ads or expanded classifieds tools? Compare plans.

Fender Rumble 500 Head with 2x 210 cabs

Thanks but my understanding is that the HPF and Compressor limiter would protect speakers and that’s what I want to achieve along with increasing the volume so I can compete with rest of band?

in your case, that solution is worse than the non-problem you are trying to solve.

The cabs are Fender Rumble 210 at 8 ohms each

This is not a problem. Your amp and speakers are well matched.

Hi yes I do have the speakers stacked vertically but it’s only 2 cabs high. Each cab is a 210

What’s being suggested is to stack them on their sides vertically. Try it.
 
Hi yes I do have the speakers stacked vertically but it’s only 2 cabs high. Each cab is a 210

Are your speaker drivers (not cabinets, the cones inside) diagonal to each other or side by side if the cabinet is sitting upright? If they're diagonal, it may not make much of a difference, but if they're side by side, it probably will.

Either way, stack orientation is always worth experimenting, as cones and ports can interact with each other differently in different orientations.

Oddly enough, (2) 2x10's won't always sound the same as a 4x10.
 
Last edited:
Are your speaker drivers (not cabinets, the cones inside) diagonal to each other or side by side if the cabinet is sitting upright? If they're diagonal, it may not make much of a difference, but if they're side by side, it probably will.

Either way, stack orientation is always worth experimenting, as cones and ports can interact with each other differently in different orientations.

Oddly enough, (2) 2x10's won't always sound the same as a 4x10.
 
I'd start with the GAIN at 12:00 and bring up the Master to volume. BASS at noon, low mids at 1:00, high mids at 11:00, and treble at 10:00. And like AH said, remove the front-end limiter/filter for now.
 
Last edited: