GK 700RB Combo Direct Out Issue

[pastypyro]

I've been setting up a rough, makeshift home studio for the past few days to get some recording done before I move. After spending about 8 hours getting the drums to sound right, I plug the direct out straight into the mixer and all is well except when I hit the button for the direct out to be supplied post EQ, I lose a signal. I have no clue what would cause this, but most likely user error. Anyone have any ideas?



Information for reference can be found here:

[Invalid or Expired Link Removed]

 

[Joe P]

...when I hit the button for the direct out to be supplied post EQ, I lose a signal...

...most likely user error. Anyone have any ideas?

Hmm. No I don't. That's even the head I use... Hm.

I can't think of anything; Master volume doesn't have anything to do with it...

You say it works fine PRE, and then turns off when you hit POST?

Joe

 

[larrytron]

The input gain : Volume affects the Post EQ if it is set quite low the signal will be lower than in pre EQ. I usually use onle the Pre EQ because the postEQ brings too much hiss for me.

Try to crank up the volume a bit and slow down the woofer and/or the boost.