- Jun 29, 2006
- 5,148
- 3,217
- Disclosures
- President, CEO, CFO, CIO, Chief Engineer, Technician, Janitor - Reiner Amplification
Started work on my "micro" head today which will be based on my new "Studio" preamp design.
12"x12"x5", ~12-14 lbs, 1175 watts at four ohm, 2.7 ohm stable, fully hand-wired, high voltage tube preamp that is transformer (Jensen) coupled to the power section, active bass, low mid, high mid, and treble with inductor driven lows and mids, full DI (second Jensen) with pre/post EQ and ground lift, preamp out, dual speakons, silent fan cooling...... quality construction with mil-spec pots, fully isolated open-frame jacks, SS hardware, teflon wire, high quality switches, caps, and electronics, vibration isolation throughout. Last of the parts should be here this week (other than the custom inductors) so I'll probably pull some late nights to get this thing rollin'.
12"x12"x5", ~12-14 lbs, 1175 watts at four ohm, 2.7 ohm stable, fully hand-wired, high voltage tube preamp that is transformer (Jensen) coupled to the power section, active bass, low mid, high mid, and treble with inductor driven lows and mids, full DI (second Jensen) with pre/post EQ and ground lift, preamp out, dual speakons, silent fan cooling...... quality construction with mil-spec pots, fully isolated open-frame jacks, SS hardware, teflon wire, high quality switches, caps, and electronics, vibration isolation throughout. Last of the parts should be here this week (other than the custom inductors) so I'll probably pull some late nights to get this thing rollin'.

