Hi,
I've searched and found many threads saying that it is a simple matter of moving jumpers. I've even received a pdf file from a forum member with instructions and a picture of the circuit board for a MarkBass LMII.
Unfortunately my circuit board in the amp head from the combo looks very different from the picture I received. Supposedly there are two jumpers to switch. I can clearly identify the one on the rear panel board. The second jumper on the pre-amp board looks different from the picture. It has a jumper but is not labeled "parallel" like the picture on the pdf and the surrounding electronic elements and board layout look very different from the picture. I don't know if the circuit board design has changed or if it is a different amp head unit in the combo (LMIII?). Perhaps this design only requires changing ONE jumper?
Does anyone have a similar document describing how to make the change specifically in the combo unit MarkBass CMD 102p 2x10?
PM me if necessary. Thanks in advance.
I've searched and found many threads saying that it is a simple matter of moving jumpers. I've even received a pdf file from a forum member with instructions and a picture of the circuit board for a MarkBass LMII.
Unfortunately my circuit board in the amp head from the combo looks very different from the picture I received. Supposedly there are two jumpers to switch. I can clearly identify the one on the rear panel board. The second jumper on the pre-amp board looks different from the picture. It has a jumper but is not labeled "parallel" like the picture on the pdf and the surrounding electronic elements and board layout look very different from the picture. I don't know if the circuit board design has changed or if it is a different amp head unit in the combo (LMIII?). Perhaps this design only requires changing ONE jumper?
Does anyone have a similar document describing how to make the change specifically in the combo unit MarkBass CMD 102p 2x10?
PM me if necessary. Thanks in advance.
